Applications
Spring loaded sensor bracket with double lip and lateral clearance. Highest tilt flexibility, highest spring travel. Rigid during approach. For high lateral acceleration (up to 2g), minimal wear, no vacuum loss.
Application Characteristics
| For vertical destacker: | + |
| For robot loader and high speed linear destackers: | + |
| For inclined sheet stacks: | ++ |
| For Tailor Welded Blanks + TWB | ++ |
(Legend: "- -" = absolutely not suited / "-" = not suited / "o" = applicable / "+" = well suited / "++" = best suited) | |
Technical Data
| Suitable sensors: | P42GS, P42AGS, PW42GS, PW42AGS |
| Diameter of suction cup: | 105mm |
| Spring travel: | approx. 70mm |
| Total height (unloaded): | 120mm |
| Weight: | approx. 0.85kg (1.87lbs) |
| Mounting: | M8 tap holes 2 out of 10 needed |
| Pressure force at 1/2 spring travel: | approx. 25N |
| Sensor mounting: | Thread M42 x 1.5 |
| Vacuum feed: | Hose 8mm OD |
| Suction delay time:* | approx. 0.1s |
| Suction cup hardness | 55 shore |
* is heavily dependent on vacuum strength, piping resistance, contact angle and contact pressure to the sheet. Sensor brackets are not suited for lifting. (except sheet is smaller than area of 3 suction cups) | |
Accessories
| Accessory: | SHX-AZ2-25 Shank for 25 mm clamp collar / swivel arm |
| SHX-AZ-BILSING Adaptor for Bilsing quick change coupling | |
| SHX-AZQ-19 Adaptor with Ø 19 mm stud for swivel arm | |
| SHX-AZQ-25 Adaptor with Ø 25 mm stud for swivel arm |